Και για να μην ξεχνιώμαστε η Yaesu έβγαλε αναβάθμιση για το 2000ρο τόσο στο firmware όσο και στο DSP.
Αναλυτικά οι αλλαγές είναι οι εξής:
Ver. 0149 MAIN CPU implements improvements (also includes all previous updates):
• The REC (Record Function) setting will be recalled when the power is turned on if REC was turned on before power was turned off.
• The CAT MW command is corrected.
• In the QMB-MT mode, when the VFO frequency is moved, the memory channel indication is cleared to 0.000.
• The DSP firmware write mode may be accessed by pressing [CONT] + [DNR] while pressing Power On.
• Holding of the [▽]F6 or [△]F7 keys will permit scrolling through the DMU Memory Channel
List, when the DMU-2000 is installed.
• The FH-2 [▽][△]keys are made the same function as the MIC-UP/DN keys.
• Corrected the CW FULL BKIN keying when used with the VL-1000 Quadra Amplifier System.
• Corrected the RX in CW FULL BKIN 30wpm.
Ver. 11.53 EDSP implements improvements (also includes all previous updates):
• The DNR algorithm is not reset between TX/RX, to eliminate the increased receive noise after a transmission.
• Increase the response of the compression level meter in conjunction with the PROC knob. (Max up to 12dB).
NOTES:
*Rotate the [METER] switch to select “COM” (Compression). We recommend setting the PROC level within the 5dB to 10dB range.
*When menu settings are saved on the DMU-2000 CF card and transferred to the new version, some previous versions may not transfer correctly. Please check your menu, update the settings, and then save the new settings to the CF card.
*After installation of Ver. 0142 ~ 0149 you may find that computer operation with PCC-2000 may not be possible for setting proper MENU items. We will release the updated PCC-2000 software when it becomes available.
